Lexmark E232 기술 지침 - 페이지 3

{카테고리_이름} Lexmark E232에 대한 기술 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Lexmark E232 8 페이지. How to reset the photoconductor page count through the printer's configuration menu
Lexmark E232에 대해서도 마찬가지입니다: 설정 (2 페이지), 빠른 참조 (2 페이지), 안전 정보 (2 페이지), 재설정 방법 (2 페이지)

페이지 인쇄

Lexmark E232/330/332 Technical Instructions

Photo 12

Photo 13

Photo 14

Photo 15

Photo 16

Step 11

To clean the developer roller, take a lint-

free cloth, add a small amount of alcohol

and soak the cloth in distilled water. Place

the developer roller axle into a drill. Clean

the developer roller using the lint-free

cloth while the roller is rotating in the

drill. (See Photo 12)

Step 12

Slide the doctor bar down toward the

developer roller opening and remove the

bar.

(See Photo 13)

Step 13

Remove the toner from the doctor

bar using compressed air or a vacuum.

Clean the contact edge of the bar using a

cotton swab and Acetone.

(See Photo 14)

Step 14

Remove the cartridge warranty sticker

from the side of the cartridge.

(See Photo 15)

Step 15

Remove the toner hopper fill cap from

the end of the cartridge. (See Photo 16)

Carefully clean the hopper using dry

compressed air or a vacuum. Do not

damage the developer roller sealing

blade that sits under the developer roller.

Step 16

Install the doctor bar so the bar

sits over the doctor bar sealing

blade attached to the toner

hopper, (See Photo 17) and

under the positioning posts on

both side of the hopper.

(See Photo 18)

Photo 17

Photo 18

Notes