Gardena 2403 사용 설명서 - 페이지 7

{카테고리_이름} Gardena 2403에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 2403 15 페이지. Turbotrimmer

페이지 인쇄

Fault

The Turbotrimmer

no longer cuts.

If you have any other problems please contact the GARDENA Customer Service.

7. Storage

Storage :

Disposal :

(in accordance with

RL 2002 / 96 / EC)

5. Unwind the filament

the lower filament) approximately 10 cm

and thread it through the eye

plastic ring

filament beforehand using a screwdriver.

The filament

over the knife

6. Only for classicCut plus : unwind the

upper filament

and fit it into the notch

cassette.

7. Pull the plastic ring

(with classicCut plus ensure that the upper filament

in the slot

8. Reinstall the filament cassette as described under 5. Mainte-

nance "Replacing the filament cassette".

Only GARDENA Service Centres and authorised specialist

GARDENA dealers may carry out repairs.

Possible cause

Filament worn or too short.

Filament cassette empty.

Filament drawn into the

cassette or stuck together.

The Turbotrimmer must be stored out of the reach of children.

v Store your Turbotrimmer in a dry place where it is protected

from frost.

Recommended storage :

We recommend that you hang your Turbotrimmer from the cable

lock. Hanging storage helps avoid unnecessary stress on the

cutting head.

The product must not be added to normal household waste. It

must be disposed of in line with local environmental regulations.

v Important: Make sure that the unit is disposed of via your

municipal recycling collection centre.

(with classicCut plus

of the

. If necessary, loosen the

may stand out max. 2 cm

a approximately 10 cm

of the filament

back over the filament cassette

of the plastic ring).

Remedy

v Lengthen the filament –

v Replace the filament cassette

v Pull the filament out of the

a is

see 4. Operation "Filament

feed (Tip mechanism for

automatic filament feed )".

– see 5. Maintenance

"Replacing the filament

cassette" ).

filament cassette (see above).