Gardena 8841 사용 설명서 - 페이지 6

{카테고리_이름} Gardena 8841에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 8841 10 페이지. Turbotrimmer
Gardena 8841에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지)

페이지 인쇄
Gardena 8841 사용 설명서
Setting the working position :
G
F
H
Setting the trimmer
to body height :
K
B
I
J
Adjusting the plant guard :
16
ATTENTION !
A
Overloading of the motor.
V When trimming with wheels, working position
2 must be set.
Working position 1 :
Working position 2 :
Trimming without
Trimming with
wheels
wheels
The angle of the handle can be set to 3 working positions.
F
1. Push slider
up and set the handle
working position (see scale
F
2. Let the slider
lock into the required working position.
Setting the handle length :
v Open clamping lever
required handle length and close clamping lever
ATTENTION ! With AccuCut 400 Li, ensure that when
adjusting the handle length the upper part of the
B
handle
is not twisted.
Adjusting the additional handle :
v Press adjusting buttons in
K
handle
to required angle and release the adjusting buttons
J
again.
When the trimmer is set to the correct body size, the body
is upright and the cutting head is angled slightly forwards in
working position.
v Hold the trimmer on the upper part of the handle
K
additional handle
angled forwards slightly.
L
Working position
L
v Turn plant guard
it locks into place.
Working position 3 :
Trimming under
obstacles
G
to the required
H
).
I
, extend upper part of handle
J
on both sides, set additional
in such a way that the cutting head is
Parking position
through 180° into the required position until
B
to
I
again.
B
and
L