Gardena 8848 사용 설명서 - 페이지 5

{카테고리_이름} Gardena 8848에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 8848 14 페이지. Turbotrimmer
Gardena 8848에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)

페이지 인쇄
Gardena 8848 사용 설명서
Setting the working position :
C
B
D
Setting the trimmer
to body height :
G
E
F
Adjusting the plant guard :
14
A
Working position 1 :
Trimming without
wheels
The angle of the handle can be set to 3 working positions.
1. Push slider
working position (see scale
2. Let the slider
Setting the handle length :
v Open clamping lever
required handle length and close clamping lever
ATTENTION ! With EasyCut 400 / 480, ensure that when
adjusting the handle length the upper part of the handle
is not twisted.
Adjusting the additional handle :
v Press adjusting buttons in
8
handle
F
again.
When the trimmer is set to the correct body size, the body
is upright and the cutting head is angled slightly forwards in
working position.
v Hold the trimmer on the upper part of the handle
additional handle
angled forwards slightly.
H
Working position
v Turn plant guard
it locks into place.
ATTENTION !
Overloading of the motor.
V When trimming with wheels, working position 2
must be set.
Working position 2 :
Trimming with
wheels
B
up and set the handle
D
B
lock into the required working position.
E
, extend upper part of handle
F
G
to required angle and release the adjusting buttons
G
in such a way that the cutting head is
H
through 180° into the required position until
Working position 3 :
Trimming under
obstacles
C
to the required
).
E
again.
on both sides, set additional
8
Parking position
8
to
8
and
H