Broadata LBO-H/DP-EAD-T 매뉴얼 - 페이지 8

{카테고리_이름} Broadata LBO-H/DP-EAD-T에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Broadata LBO-H/DP-EAD-T 18 페이지. Link bridge fiber optic hdmi/displayport transmitter system

페이지 인쇄

2.5 Audio Interface

The audio interface supports one stereo channel high fidelity

analog or digital transmission. Line-level audio signals or SPDIF

digital signals are connected to the LBO-H/DP-EAD-T unit. The

following steps illustrate the installation procedures for audio

devices.

To send audio signals, label and connect one stereo audio-jack

cable to the "AUDIO" connector of the line level or digital audio

source. On the LBO-H/DP-EAD-T unit, connect the other end of

the cables to the front panel stereo jack connector labeled

"AUDIO IN" (see Figure 2-2).

2.6 Serial Data Interface

To transmit RS232/ IR data connect data source to the terminal

block shown in Figure 2-2.

The LBO-H/DP-EAD-T transmits two channels of data signals.

Follow the procedures for installing data terminal devices.

1. Label and connect one serial data cable to the user's RS-232

data port.

2. Connect the other end of this cable to the front panel data

terminal block connector on the LBO-H/DP-EAD-T per the pin

out shown in Figure 2-2.

Broadata Technical Support, [email protected]

LBO-H/DP-EAD-T User Manual

Link Bridge

Fiber Optic HDMI/DisplayPort Transmitter