Broadata Link Bridge LBC-HDMI-R-WP 사용자 설명서 - 페이지 7

{카테고리_이름} Broadata Link Bridge LBC-HDMI-R-WP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Broadata Link Bridge LBC-HDMI-R-WP 20 페이지. Hdmi wall plate hdbaset transmission system

페이지 인쇄

LBC-HDMI-T/R-WP User's Manual

Link Bridge

HDMI Wall Plate HDBaseT Transmission System

2.0 SETUP

The BCI LBC HDBaseT Extender Series units are used in pairs. One

LBC-HDMI-T-WP transmitter unit is located at the near-end (source)

and connected through a single category cable, to the LBC-HDMI-T-WP

receiver shown below and located at the far-end (sink) of the link.

Figure 2-1 depicts a typical installation for the LBC-HDMI-T/R-WP pair.

LBC-HDMI-T-WP with LBC-HDMI-R-WP Transmission Pair

2.1 Mounting

Before installing the units into your housing, make sure there is

enough space to pull and connect both the electrical and category

cables without stressing them beyond the manufacturer's

limitations (also known as the minimum bend radius).

2.2 Cabling and Connectors

In order to setup the LBC-HDMI-T/R-WP properly, make sure

to observe the following instructions when installing the proper

cables. The LBC-HDMI-T/R-WP requires two parts to the

cabling setup, the video signal and the transmission connections.

Figure 2-1

Broadata Technical Support, (800) 214-0222