Corvus systems TRS-80 II 설치 매뉴얼 - 페이지 11

{카테고리_이름} Corvus systems TRS-80 II에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Corvus systems TRS-80 II 19 페이지. Corvus systems disk system installation guide

페이지 인쇄

Connect the 34 pin flat cable to the disk drive port labelled

PROCESSOR on the rear bezel. The cable must exit

downward,

with

the

red stripe on the right, as you look

directly

at the rear of the drive. (Note that this cable must

not

coiled because coiling increases signal distortion.)

Remove the screws securing the top of your TRS-80 Model

II computer and remove the cover.

Remove the expansion plug cover from the lower rear area

of your Model II and replace the cover plate with the one

supplied with your Corvus interface card. You will notice a

notch at the bottom of the cover plate to allow for the exit

of the Corvus flat cable. Secure the cover plate to the

Model II after you have routed the flat cable through the

expansion port area.

View of

TRS-80 Model II Computer Showing

Corvus

Interface Card with Cable on Left

Side of Card Cage.