Gardena 9838 운영자 매뉴얼 - 페이지 6
{카테고리_이름} Gardena 9838에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 9838 14 페이지. Battery hedge trimmer
Gardena 9838에 대해서도 마찬가지입니다: 운영자 매뉴얼 (14 페이지), 운영자 매뉴얼 (10 페이지), 운영자 매뉴얼 (10 페이지), 운영자 매뉴얼 (9 페이지)
페이지 인쇄
2
3. Put both screws
in the threaded holes in the hedge
trimmer.
Do not push the front start lever
this.
3. OPERATION
DANGER! Risk of injury!
Cut injury when the hedge trimmer starts
accidentally.
v Wait for the blade to stop, remove the battery
and slide the protective cover over the blade
before you adjust or transport the hedge
trimmer.
To charge the battery [ Fig. O1 / O2 ]:
CAUTION!
Overvoltage damages the battery and the
battery charger.
v Make sure that you use the correct mains
voltage.
For the GARDENA Battery Hedge Trimmers
Art. 9837-55 / 9838-55 there is no battery in the
scope of delivery.
Before you use the battery the first time, the battery must
be completely charged.
The lithium-ion battery can be charged in any state of
charge and the charging process can be disconnected at
any time without to damage the battery (no memory
effect).
1. Push both locking buttons
C
from the battery holder
2. Connect the battery charger
3. Connect the battery charger cable
When the charging control lamp
flashes green the battery is being charged.
When the charging control lamp
illuminates green the battery is completely charged
(Charging time, see 7. TECHNICAL DATA).
4. Examine the charge status regularly while you charge.
Y
5. When the battery
is completely charged, disconnect
Y
the battery
from the charger
6. Disconnect the charger
Battery charging indicator [ Fig. O3 ]:
Battery charging indicator during charging:
«
100 % charged
,
«
66 – 99 % charged
«
33 – 65 % charged
«
0 – 32 % charged
3
while you are doing
>
and remove the battery
.
X
into a mains socket.
V
to the battery
å
at the charger
å
at the charger
X
.
X
from the mains.
∑
€
and
illuminate (for 60 sec.)
∑
€
and
illuminate,
flashes
∑
illuminates,
flashes
flashes
4. Tighten both screws
Make sure that the screws
3
start lever
can be completely pushed.
Battery charging indicator during operation:
v Push the button
66 – 99 % charged
33 – 65 % charged
10 – 32 % charged
0 – 10 % charged
Work positions:
The hedge trimmer can be operated in 3 positions.
• Side trimming [ Fig. O4 ]
• High trimming [ Fig. O5 ]
• Low trimming [ Fig. O6 ]
To start the hedge trimmer [ Fig. O7 ]:
DANGER! Risk of injury!
Risk of injury if the product does not stop
when you release the start levers.
v Do not bypass the safety devices or switches.
For example do not attach the start levers to the
handle.
To start:
Y
The product is provided with a two-handed safety
device (2 start levers) to prevent the product from
being turned on by accident.
Y
Y
1. Put the battery
.
audibly engages.
2. Remove the protective cover from the blade.
3. Hold the front handle
3
front start lever
4. Hold the main handle
the rear start lever
The hedge trimmer starts.
To stop:
1. Release the two start levers
The hedge trimmer stops.
2. Slide the protective cover over the blade.
3. Push both locking buttons
from the battery holder
2
.
2
are tightened and the
y
on the battery.
«
∑
€
,
and
illuminate
«
∑
and
illuminate
«
illuminates
«
flashes
C
into the battery holder
1
with one hand and pull the
.
0
with the other hand and pull
q
.
3
q
/
.
>
and remove the battery
C
.
until it
Y
13