Gardena 9838-20 사용 설명서 - 페이지 10

{카테고리_이름} Gardena 9838-20에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 9838-20 17 페이지. Accu turbotrimmer
Gardena 9838-20에 대해서도 마찬가지입니다: 운영자 매뉴얼 (14 페이지), 운영자 매뉴얼 (10 페이지), 운영자 매뉴얼 (9 페이지)

페이지 인쇄
Gardena 9838-20 사용 설명서

8. Troubleshooting

DANGER!
Risk of cutting
injuries!
Replacing the plastic blade:
s
B
Problem
The Trimmer is not cutting
cleanly or not cutting at all
The trimmer vibrates severely
The trimmer does not start
The trimmer stops.
ß
Error-LED
flashes
W
Charging indicator lamp
the charger does not light up
22
Risk of injury from blade!
v R emove the battery immediately in the event of faults!
DANGER! Risk of cutting injuries!
v N ever use metal cutting elements or spare parts
The blades may only become worn to half the original length
A
at most. Only use original GARDENA Spare Blades.
Spare blades are available from your GARDENA dealer or
direct from GARDENA Service.
• GARDENA Spare Blades for Turbotrimmer
Disassembling the plastic blade:
1. Turn the trimmer over.
e
2. Press end of blade down slightly (A), slide blade
through blade carrier
Assembling the plastic blade:
v S lide new blade
s
carrier
When the new blade is correctly inserted, it can be moved more
easily.
Possible Cause
Blade worn or too short.
Blade broken off.
The blade is excessively worn
and creates an unbalance.
Battery is flat.
Battery not pushed onto the
handle properly.
Motor blockage.
Battery overload.
High temperature. The allowed
operation temperature was
exceded.
9
on
Battery charger or charging
cable not plugged in properly.
and accessories not intended for use by GARDENA.
s
(B) and pull out.
e
from inside through slot in metal of blade
until it snaps into place.
Art. No. 5368
e
inside
Remedy
v R eplace blade.
v R eplace blade.
v R eplace blade.
v Charge battery
(see 4. Initial Operation).
v Push battery onto the handle
and make sure that the lock-
ing buttons snap in correctly.
v Unblock and restart the
device.
v Wait for 10 sec. Press button
ß
on the battery and restart.
B
v Leave battery to cool for
approx. 15 min. Press button
ß
on the battery and restart.
B
v Plug in battery charger and
charging cable properly.