Gardena AccuCut 400 Li 사용 설명서 - 페이지 5
{카테고리_이름} Gardena AccuCut 400 Li에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena AccuCut 400 Li 10 페이지. Turbotrimmer
Gardena AccuCut 400 Li에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지), 사용 설명서 (14 페이지)
페이지 인쇄
4. Initial Operation
Charging the battery :
0
A
A
E
D
5. Operation
RISK OF INJURY !
Before using for the first time, the battery must be fully charged.
Charging time (for uncharged battery) approx. 3 hrs.
The lithium-ion battery can be charged in any state of charge,
and the charging process can be interrupted at any time without
harming the battery (no memory effect).
WARNING !
A
Overvoltage damages batteries and the battery
charger.
V Ensure the correct mains voltage.
1. Press the locking buttons in
the upper part of the handle
2. Plug the plug of the charger cable
3. Plug battery charger
B
The charging indicator lamp
up red. The battery is being charged.
When the charging indicator lamp
is fully charged.
4. First remove the charging cable from the charging socket and
then unplug the battery charger from the mains socket.
5. Push the battery
Avoid exhaustive discharge :
Do not wait until the blade comes to an absolute stop (battery
totally discharged) as this shortens the battery life.
C
v If the output of the trimmer decreases noticeably, charge
the battery.
If the battery has been totally discharged, the LED will flash at
the start of charging. If the LED is still flashing after an hour, a
fault has occurred (see 8. Troubleshooting).
Risk of injury if the Turbotrimmer does not switch off when
you release the start button.
V Never bypass the safety devices (by binding the start
button to the handle, for example).
0
and remove the battery
B
.
C
into the battery
D
into a mains socket.
E
on the battery charger lights
E
lights up green, the battery
A
down onto the upper part of the handle
A
from
A
.
B
.
15