Gardena EasyCut 450/50 운영자 매뉴얼 - 페이지 6
{카테고리_이름} Gardena EasyCut 450/50에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena EasyCut 450/50 8 페이지. Electric hedge trimmer
Gardena EasyCut 450/50에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지), 사용 설명서 (14 페이지), 사용 설명서 (14 페이지), 사용 설명서 (14 페이지), 사용 설명서 (14 페이지)
페이지 인쇄
To clean the hedge trimmer [ Fig. M1 ]:
DANGER! Electric shock!
Risk of injury and risk of damage to property.
v Do not clean the product with water or with a water jet
(in particular high-pressure water jet).
1. Clean the product with a damp cloth.
2. Clean the airflow slots with a soft brush (do not use a screwdriver).
2
3. Lubricate the blade
with a low viscosity oil (e. g. GARDENA spray-oil
Art. 2366). Avoid contact with the plastic parts.
4. STORAGE
To put into storage [ Fig. S1 ]:
The product must be stored away from children.
1. Disconnect the mains cable.
2. Clean the product (see 3. MAINTENANCE) and slide the protective
1
2
cover
over the blade
.
3. Stowe the product in a dry area where it has protection from frost.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal household waste.
It must be disposed of in line with local environmental regulations.
IMPORTANT!
v Dispose of the product through or via your municipal recycling
c ollection centre.
5. TROUBLESHOOTING
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Before you troubleshoot the product, make sure that the mains
cable is disconnected and the protective cover
the blade
2
.
Problem
Possible Cause
Product does not start
Extension cable not connected
or damaged.
Blade blocked.
Product can no longer be
Start button is stuck.
stopped
Hedge is not cleanly cut
Blade blunt or damaged.
NOTE: For any other malfunctions please contact the GARDENA service depart-
ment. Repairs must only be done by GARDENA service departments or specialist
dealers approved by GARDENA.
6. TECHNICAL DATA
Electric Hedge Trimmer
Unit
Value
EasyCut 420/45
(Art. 9830)
Motor power consumption
W
420
Mains voltage /
V / Hz
230 / 50
Mains frequency
Strokes
/min.
3,800
Length of blade
cm
45
Tooth gap of blade
mm
18
Weight
kg
2.7
(approx.)
Sound pressure level L
84
1)
dB (A)
PA
Uncertainty k
PA
Sound power level L
2)
WA
measured / guaranteed
94 / 97
dB (A)
Uncertainty k
2.04
WA
Hand/arm vibration a
3.8
1)
m/s
2
vhw
Uncertainty k
1.5
a
Measuring process complying with:
EN 60745-2-15
1)
1
is slid over
Remedy
v
Connect the extension cable
or if necessary replace it.
v
Remove obstacle.
Disconnect the mains cable
v
and loosen start buttons.
v
Have blade replaced by
GARDENA Service.
Value
Value
EasyCut 450/50
EasyCut 500/55
(Art. 9831)
(Art. 9832)
450
500
230 / 50
230 / 50
3,800
3,800
50
55
18
18
2.8
2.8
84
84
3
3
3
94 /97
94 / 97
2.04
2.04 dB (A)
3.8
3.0
1.5
1.5
RL 2000/14/EC amended by 2005/88/EC
2)
NOTE: The stated vibration emission value has been measured according to
a standardized test procedure and can be used for comparison of one electric
power tool with another. It can also be used for preliminary evaluation of expo-
sure. The vibration emission value can vary during actual use of the electric power tool.
7. ACCESSORIES
GARDENA Maintenance Oil
Extends the life of the blade.
GARDENA Collecting Bag
Easy and comfortable collecting of the chopped
Cut&Collect EasyCut
property.
8. SERVICE / WARRANTY
Service:
Please contact the address on the back page.
Warranty:
In the event of a warranty claim, no charge is levied to you for the services
provided.
GARDENA Manufacturing GmbH offers a two-year warranty (effective
as of the date of purchase) for this product. This warranty includes all
significant defects of the product that can be proved to be material or
manufacturing faults. This warranty is fulfilled by supplying a fully functional
replacement product or by repairing the faulty product sent to us free of
charge; we reserve the right to choose between these options. This ser-
vice is subject to the following provisions:
• The product was used for its intended purpose as per the recommen-
dations in the operating instructions.
• Neither the purchaser nor a third party has attempted to repair the
product.
This manufacturer's warranty does not affect warranty entitlements against
the dealer / retailer.
If problems arise with this product, please contact our Service depart-
ment or send the defective product along with a brief description of the
fault to GARDENA Manufacturing GmbH, making sure to have sufficiently
covered any shipping costs and to have followed the relevant postage
and packaging guidelines. A warranty claim must be accompanied by
a copy of the proof of purchase.
Consumables:
The blade and excentric drive are consumables and are not included in the
guarantee.
Art. 2366
Art. 6001
9