Gardena EasyCut 50-Li 사용 설명서 - 페이지 5
{카테고리_이름} Gardena EasyCut 50-Li에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena EasyCut 50-Li 14 페이지. Cordless hedge trimmer
Gardena EasyCut 50-Li에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)
페이지 인쇄
3. Assembly
A
0
Fitting the front handle :
1
2
3
2
4. Initial Operation
Charging the battery :
6
5
14
DANGER ! Risk of physical injury !
Cutting injuries can be caused if the hedge trimmer
A
does switch on unintentionally.
V Remove the battery before assembling the
hedge trimmer (see 4. Operation) and slide the
protective cover
ATTENTION ! Safety guard !
The guide handle
A
2-handed trigger when the spring
inserted.
1. Insert the wide side of the
z
spring
into the lower
S
z
casing
and the lower side
a
into the upper casing
close the guide handle
3
2. Push the guide handle
the slot in the hedge trimmer
and ensure it is fully in place
and the handle hole
up with the threaded hole
3. Secure the guide handle
hedge trimmer using the two screws
WARNING !
Overvoltage damages batteries and the battery
A
charger.
V Ensure the correct mains voltage.
Before using for the first time, the battery must be fully charged.
Charging time (for uncharged battery) see 10. Technical Data.
The lithium-ion battery can be charged in any state of charge,
and the charging process can be interrupted at any time without
harming the battery (no memory effect).
So that the fully charged battery is not discharged, the battery
should be disconnected from the battery charger.
4
1. Press the locking buttons in
the handle
2. Plug the plug of the charger cable
3. Plug battery charger
0
over the cutter blade.
1
is only a safety guard for the
z
S
b
and
1
.
1
over
2
is lined
2
.
1
to the
4
and remove the battery
6
.
8
into a mains socket.
z
is correctly
S
b
a
3
.
5
7
5
into the battery
.
from