Gardena ErgoCut 48-Li 사용 설명서 - 페이지 5

{카테고리_이름} Gardena ErgoCut 48-Li에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena ErgoCut 48-Li 14 페이지. Cordless hedge trimmer

3. Initial Operation

Charging the battery :

WARNING !

Overvoltage damages batteries and the battery

charger.

V Ensure the correct mains voltage.

Before using for the first time, the battery must be fully charged.

Charging time (for uncharged battery) see 9. Technical Data.

The lithium-ion battery can be charged in any state of charge,

and the charging process can be interrupted at any time without

harming the battery (no memory effect).

So that the fully charged battery is not discharged, the battery

should be disconnected from the battery charger.

1. Press the locking buttons in

the handle

2. Plug the plug of the charger cable

3. Plug battery charger

Charging indicator lamp

The battery is being charged.

Charging indicator lamp

The battery is fully charged.

(For charging time, see 9. Technical Data.)

4. First remove the charging cable

and then unplug the battery charger

5. Push the battery

Avoid exhaustive discharge :

Do not wait until the blade comes to an absolute stop (battery

totally discharged) as this shortens the battery life.

v If the output of the hedge trimmer decreases noticeably,

charge the battery.

If the battery has been totally discharged, the LED will flash at

the start of charging. If the LED is still flashing after an hour, a

fault has occurred (see 7. Troubleshooting).

and remove the battery

into a mains socket.

lights up red :

lights up green :

from bottom onto the handle

into the battery

from the charging socket

from the mains socket.

from