Gardena powerCut 2404 사용 설명서 - 페이지 5
{카테고리_이름} Gardena powerCut 2404에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena powerCut 2404 12 페이지. Turbotrimmer
Gardena powerCut 2404에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지)
페이지 인쇄
E
4. Maintenance
Risk of injury !
Risk of injury !
Cleaning the cover
and ventilation slots :
Replacing the filament
cassette :
I
J
E
K
N
M
12
1. Leave the motor running.
2. Hold the cutting head
ground and tap the filament cassette
7
of the Turbotrimmer on the ground
several times in succession (approx.
3 times) (avoid applying sustained
pressure to the Turbotrimmer).
The filament is lengthened automatically.
Listen for the audible switching action.
The filament limiter
There is a risk of injury from the cutting filament !
V Always unplug the mains plug of the Turbotrimmer be-
fore carrying out maintenance work !
Risk of injury and risk of damage to property !
V Never clean the Turbotrimmer under running water or
with a water jet (in particular a high pressure water jet).
The ventilation slots must always
be free of dirt.
v Remove any grass and dirt from
the cover
after each use.
Risk of injury !
A
V Never use metallic cutting elements or replacement
parts and accessories not provided by GARDENA.
Only use original GARDENA Filament Cassettes. You can
order Replacement Filament Cassettes from your GARDENA
dealer or directly from the GARDENA Customer Service.
• Filament Cassette for Turbotrimmer powerCut : Art. No. 5367-20
J
1. Unplug the mains plug.
2. Turn over the Turbotrimmer and rest it on the rubber buffer
of the handle.
3. Release the cassette cover
and remove the cover.
L
4. Remove the filament cassette
5. Remove any dirt.
6. Pull approximately 5 cm of the filament
filament cassette
7. Insert the filament cassette
so that the filament
8. Fit the cassette cover
that you hear both locking clips
When replacing the cover, ensure that the filament is inside the
metal case and is not trapped.
v If the cassette cover
filament cassette
is completely in the filament cassette holder
7
parallel to the
F
adjusts the filament to the correct length.
G
and ventilation slots
I
by pressing both locking clips
E
E
through the hole in the plastic ring
E
in the filament cassette holder
K
is inside the metal case
I
on the filament cassette holder
J
I
cannot be touched down, turn the
E
to and fro, until the filament cassette
E
E
H
H
G
.
K
out of the new
N
.
click into place.
M
.
F
J
L
.
M
M
so
E