KitchenAid Architect Series II KCMS1555SSS 설치 매뉴얼 - 페이지 4
{카테고리_이름} KitchenAid Architect Series II KCMS1555SSS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid Architect Series II KCMS1555SSS 8 페이지. Built-in trim kit
KitchenAid Architect Series II KCMS1555SSS에 대해서도 마찬가지입니다: 데이터시트 (1 페이지), 사용 및 관리 매뉴얼 (16 페이지)
페이지 인쇄
2. Peel off backing of double-sided tape. Align the duct
assembly screw hole to the existing screw hole on left side of
microwave oven, and attach the duct assembly to the oven.
Press down firmly on ducts, then fasten with existing screw.
A
A. Existing screw
Anti-Tip Bracket Installation
1. On cutout floor, use template to mark hole centers for anti-tip
bracket. Be sure to align the centerline of template to
centerline of cutout floor.
(Dimensions as shown are not to scale.)
A. 1 " (3.81 cm)
B. 3" (7.62 cm)
C. 16" (40.64 cm)
2. Drill 2 holes for anti-tip bracket. (Use
3. Install anti-tip bracket onto cutout floor using two
A
B
A. " screws
B. Anti-tip bracket
4
A
B
C
D
E
F
D. Cutout opening
E. Cutout floor
F. Centerline
" drill.)
Microwave Oven Placement
1. Slide microwave oven partway into cutout opening.
NOTE: Bottom bracket must be flat against cutout floor in order
to correctly engage with anti-tip bracket.
2. Plug in microwave oven.
3. Make sure microwave oven is centered within cutout opening
and slide it into place, engaging anti-tip bracket.
4. Drill pilot holes through positioning flange. (Use
Then install three
A
B
C
" screws.
A
B
C
A. Bottom duct
B. Anti-tip bracket
C. Bottom bracket
" screws at front of bottom duct.
A. Cutout opening
B. Positioning flange
C. " screws
" drill.)