KitchenAid Architect Series KBMS1454R 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} KitchenAid Architect Series KBMS1454R에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid Architect Series KBMS1454R 8 페이지. Built-in microwave oven
KitchenAid Architect Series KBMS1454R에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (16 페이지), 사용 및 관리 매뉴얼 (18 페이지)
페이지 인쇄WARNING
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or other injury.
1. Empty microwave oven of any loose contents.
2. Loosen 2 existing screws on each side of microwave oven.
The screws are located at the same height as the door handle,
and they are the 2 screws closest to the front of the
microwave oven on each side.
A. Existing screws
B. Right side bracket
C. Proper side bracket placement
3. Slide the left and right side brackets under the existing screw
heads, as shown, and then tighten the screws. Use the narrow
side brackets (LEFT or RIGHT 27") for 27" (68.6 cm) opening,
or wide side brackets (LEFT or RIGHT 30") for 30" (76.2 cm)
opening.
4. Hold Z-brackets against the outside edges of cutout opening
with bottom ends of brackets resting on the cutout floor, as
shown. Mark holes.
Install the Microwave Oven
27" (68.6 cm) or 30" (76.2 cm) Installation Only
A
B
C
NOTE: The lower corners of the wood cabinet must be right
angles for proper Z-bracket placement.
A
B
C
A. Z-brackets (2)
B. 1/2" T-10 screws (4)
C. Cutout opening
5. Drill holes into the inside edges of cutout opening using 5/64"
(2 mm) drill bit.
6. Attach Z-brackets to side edges of cutout opening using four
1/2" T-10 screws.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7. With the microwave oven near the opening, plug the
microwave oven into the grounded 3-prong outlet.
8. Using 2 or more people, slide microwave oven all the way into
the opening.
7