Gardena 1874 사용 설명서 - 페이지 10

{카테고리_이름} Gardena 1874에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 1874 17 페이지. Water computer
Gardena 1874에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 운영자 매뉴얼 (17 페이지)

페이지 인쇄

Exit direct sensor control

[Level 5] :

Read / modify watering

programmes :

Example :

Watering duration = 10 minutes

Watering begins when the sensor registers dry (Sensor dry)

between 20:00 and 06:00, and ends when the sensor registers

wet (Sensor wet) or after 10 minutes at the latest.

2 hours after the end of watering, if dry is registered (Sensor

dry), watering is again initiated and with wet (Sensor wet) there

is no further watering etc. for 2 hours up to max. 06:00. There is

no watering between 06:00 and 20:00.

The watering duration is preset at the factory to 30 minutes.

Emergency programme (the moon

is inserted in the direct sensor control, or the connection cable

is faulty, watering will take place every 24 hours. The watering

duration depends on the set run time but is limited to a maximum

of 30 minutes.

1. Press Menu button 4 times.

The moon

flashes on the display.

2. Select a different watering cycle with the ▼-▲ buttons and

confirm with the OK button.

If a value in a programme is to be changed, this can be done

without changing the other values in the programme.

1. Press the Menu key twice.

Start and the hours flash on the display.

2. Press the Menu button to jump to the next programme

level

– or –

Change programme data with the ▼-▲ buttons and

confirm with the OK button.

When the watering duration is changed while a program is

running, the current watering cycle is ended.

C) Manual watering :

Each valve can be opened or closed manually at any time.

A program-controlled open valve can also be closed early

without changing the program data (watering start time,

watering duration and watering frequency). The controller must

be fitted.

1. Select Valve 1 (

▼-▲ buttons.

2. Press Man.-key to open the valve manually

(or to close an open valve).

Run Time and the watering time in minutes (set to

in the works) flash for 10 seconds on the display.

flashes) : If no sensor

V1) or Valve 2 (V2

) with the

minutes