Gardena 4000/5 사용 설명서 - 페이지 9

{카테고리_이름} Gardena 4000/5에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 4000/5 18 페이지. Garden pump
Gardena 4000/5에 대해서도 마찬가지입니다: 사용 설명서 (10 페이지), 사용 설명서 (17 페이지), 사용 설명서 (12 페이지), 운영자 매뉴얼 (14 페이지), 운영자 매뉴얼 (11 페이지), 운영자 매뉴얼 (10 페이지), 운영자 매뉴얼 (10 페이지), 사용 설명서 (19 페이지), 사용 설명서 (13 페이지), 사용 설명서 (17 페이지)

Red Power LED is lit

The pump is connected to the mains power.

The pump functions in the normal operating mode.

Green LED is lit

The pump is connected to the mains and the pump is running.

Once the pump has reached the max. pump pressure, the pump

switches off (the green LED extinguishes) and the pump functions

in the normal operating mode.

Green LED flashing slowly (once a second)

The flow rate on the delivery side is too low (below 90 l / h).

The pump continues to run and then switches off. It turns on

again as soon as the switching pressure of approx. 2.2 bar

has been reached (e.g. in the case of a leak).

The pump must be switched off just before you finish draining

water from the unit.

Green LED flashing quickly (four times a second)

The flow rate on the inlet side is too low (below 400 l / h).

The pump continues to run for approx. 40 seconds. If normal

operation is not achieved during this time, the pump switches

off and the control unit changes to the "automatic self-priming

mode".

Note: The pump can be switched on again at any time

by pressing the RESET button..

Yellow LED flashing slowly (once a second)

The amount of water is too low when restarting the pump.

The pump runs through the first "priming cycle". If the normal

operating mode is not achieved, the pump switches off and the

control unit changes to the "auto-matic self-priming mode".

Note: The pump can be restarted at any time by pressing the

RESET button.

Yellow LED flashing quickly (four times a second)

Alarm which indicates if the amount of water is too low when

the pump is operating in the normal mode. The control unit

changes to the "automatic self-priming mode".

Note: The pump can be restarted at any time by pressing the

RESET button.