Avaya 4600 Series 안전 지침
{카테고리_이름} Avaya 4600 Series에 대한 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Avaya 4600 Series 11 페이지. Infrared dialing
Avaya 4600 Series에 대해서도 마찬가지입니다: 설치 및 안전 지침 (11 페이지), 연결 (14 페이지), 제품 정보 (2 페이지), 매뉴얼 (4 페이지)
페이지 인쇄
4600 Series IP Telephone
Safety Instructions
For all IP Telephone documentation,
go to http://www.avaya.com/support
IMPORTANT USER SAFETY INSTRUCTIONS
The most careful attention has been devoted to quality standards in the manufacture of
your new telephone. Safety is a major factor in the design of every set. But, safety is
YOUR responsibility too.
Please read carefully the helpful tips listed below and on the next page. These
suggestions will enable you to take full advantage of your new voice terminal. Then,
retain these tips for later use.
!
WARNING:
All powering over telecommunication wiring must be via UL listed power supplies with
outputs of 42-56 Volts DC,
1.3 Amps DC.
This telephone is NOT for residential use. It is for business systems applications ONLY.
It will NOT operate on public networks. It MUST BE connected to a DEFINITY
Enterprise Communications Server through an ethernet LAN. Use in a residential
environment could result in an electrical short circuit when the telephone wiring is set
up to provide other applications, for example, for appliance control or power
transformers. The optional AC power used in these applications may create a safety
hazard by placing a direct short circuit across the telephone wiring.
!
WARNING
(4606/4612/4624/4630):
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
Note: the 4601, 4602, 4602SW, 4610SW, 4620, 4620SW, 4621SW, 4622SW, 4625SW,
4630SW, and 4690 IP Telephones are Class B products and the preceding Warning
does not apply to them.
!
WARNING:
The ethernet interface should not leave the building premises unless connected to
telecommunications devices providing primary and secondary protection, as
applicable.
Use
When using your telephone equipment, the following safety precautions should always
be followed to reduce the risk of fire, electric shock, and injury to persons.
•
Read and understand all instructions.
•
Follow all warnings and instructions marked on the telephone.
•
This telephone can be hazardous if immersed in water. Do not use this product near
water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet
Comcode: 700361314
555-233-779
Issue 8, March 2005
basement or near a swimming pool. To avoid the possibility of electric shock, do not
use it while you are wet. If you accidentally drop the telephone into water, do not
retrieve it until you have first unplugged the line cord from the modular wall jack.
Then, call service personnel to ask about a replacement.
•
Avoid using the telephone during electrical storms in your immediate area. There is
a risk of electric shock from lightning. Urgent calls should be brief. Even though
protective measures may have been installed to limit electrical surges from entering
your business, absolute protection from lightning is impossible.
•
If you suspect a natural gas leak, report it immediately, but use a telephone away
from the area in question. The telephone's electrical contacts could generate a tiny
spark. While unlikely, it is possible that this spark could ignite heavy concentrations
of gas.
•
Never push objects of any kind into the equipment through housing slots since they
may touch hazardous voltage points or short out parts that could result in a risk of
electric shock. Never spill liquid of any kind on the telephone. If liquid is spilled,
however, refer servicing to proper service personnel.
•
To reduce the risk of electric shock, do not disassemble this telephone. There are
no user serviceable parts. Opening or removing covers may expose you to
hazardous voltages. Incorrect reassembly can cause electric shock when the
telephone is subsequently used.
Service
•
Before cleaning, unplug the telephone from the ethernet jack and the power supply.
Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
•
Unplug the telephone from the modular wall jack. Be sure to refer servicing to
qualified service personnel when these conditions exist:
— If liquid has been spilled into the telephone.
— If the telephone has been exposed to rain or water.
— If the telephone has been dropped or the housing has been damaged.
— If you note a distinct change in the performance of the telephone.
Declaration of Conformity
To download the Declaration of Conformity (DoC) for this equipment, visit http://
www.avaya.com/support
SAVE THESE INSTRUCTIONS
When you see this warning symbol on the product, refer to
!
this instructions booklet for more information before
proceeding.
1