Avaya 9110 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Avaya 9110에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avaya 9110 11 페이지. Remote gateway

Standard 1.1

Avaya Remote GatewayInstallation

You need a 10BaseT Ethernet cable to provide the Avaya Remote Gateway 911x

series unit with voice over IP capability. For instructions on how to install a

Remote Gateway 911x unit turn to

page

You need the following tools to install the Remote Gateway 9110 circuit card in

your Meridian (M2000 series) digital telephone:

•

To insert the Avaya Remote Gateway 9110 circuit card:

antistatic ESD wrist strap (recommended)

Phillips screwdriver

Disconnect the telephone-side connection of the RJ11 TCM telephone cable,

(the other end connects to the wall jack).

Place the telephone on a flat surface with the keypad facing down and remove

the footstand (2 screws on the bottom).

Note: Ensure that you are properly grounded with an approved ESD strap.

Pop out the front panel inserts in the footstand of the telephone to make the

connections accessible when you install the circuit card. Refer to

the Avaya Remote Gateway 911x series unit to the network" on page

Remove the circuit card from its antistatic bag and insert the leading edge of

the circuit card under the two brackets in the footstand. Use both hands to

push forward until the card snaps into place under the brackets.

Note: Two holes on either side of the circuit card align with

corresponding holes in the footstand.

"Installing the Remote Gateway 911x unit" on

Avaya Remote Gateway 911x Series Quick Start Guide

"Connecting