Gardena C 1030 plus 사용 설명서 - 페이지 5

{카테고리_이름} Gardena C 1030 plus에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena C 1030 plus 15 페이지. Water computer
Gardena C 1030 plus에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)

Gardena C 1030 plus 사용 설명서
4. Putting Your Water Computer into Operation
Insert battery:
E
Connect Water Computer :
H
G
I
Connect soil moisture
or rain sensor (optional) :
E
J
The Water Computer must only be operated with a 9 V alkali-
manganese (alkaline) battery type IEC 6LR61.
E
1. Remove controller
housing of the Water Computer.
2. Insert battery in the battery
F
compartment
. Observe
z
correct polarity
P
shows all the LCD-symbols for
2 seconds and then moves to
the time / day of week level.
E
3. Install controller
Set display to 24-hours or 12-hours (am / pm) :
The factory setting is the 24-hour display.
v Press the Man. button continuously while inserting the
battery.
The Water Computer is fitted with a sleeve nut
(G 1 " ) (33.3 mm) thread. The adaptor supplied
Water Computer to be connected to taps with a (G ³⁄₄ " ) thread
(26.5 mm).
1. For tap with a G ³⁄₄ " (26.5 mm) thread :
H
Screw adaptor
on to the tap manually (do not use pliers).
G
2. Screw sleeve nut
thread by hand (do not use pliers).
3. Screw tap connector
Apart from scheduled watering there is also the option of including
how damp the soil is or rainfall into the watering programme.
If the soil is damp enough, the programme will be stopped, or a
programme will be prevented from starting. Manual operation is
possible at all times.
E
1. Remove controller
2. Place soil moisture sensor in the watered area
– or –
place rain sensor (with extension cable if necessary)
outside the watered area.
Insert the sensor in the sensor connection
Computer.
It can take up to 1 min. until the status of the sensor is shown
on the display.
An adapter cable may be required to connect older sensors,
which can be purchased from GARDENA Service,
GARDENA Adapter cable Art. No. 1189-00.600.45.
from the
z
P
. The display
on the housing again.
of the Water Computer on to the adaptor
I
on to the Water Computer.
from the housing of the Water Computer.
F
G
for taps with
H
allows the
J
of the Water
5