Makita 197413-5 사용 설명서 - 페이지 7
{카테고리_이름} Makita 197413-5에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 197413-5 13 페이지. Cordless cutter
Makita 197413-5에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사용 설명서 (12 페이지)
페이지 인쇄
Position of
Speed
speed
change lever
1
Low
2
High
To change the speed, switch off the tool first. Select
the "2" side for high speed or "1" for low speed but high
torque. Be sure that the speed change lever is set to the
correct position before operation.
If the tool speed is coming down extremely during the
operation with "2", slide the lever to the "1" and restart
the operation.
Selecting the action mode
CAUTION:
Always set the ring correctly to
your desired mode mark. If you operate the tool
with the ring positioned halfway between the
mode marks, the tool may be damaged.
CAUTION:
When you change the position
from "
" to other modes, it may be a little dif-
ficulty to slide the action mode changing ring. In
this case, switch on and run the tool for a second
at the "
" position, then stop the tool and slide
the ring to your desired position.
1
► 1 . Action mode changing ring 2. Adjusting ring
3. Graduation 4. Arrow
This tool has three action modes.
•
Drilling mode (rotation only)
•
Hammer drilling mode (rotation with
hammering)
•
Screwdriving mode (rotation with clutch)
Select one mode suitable for your work. Turn the
action mode changing ring and align the mark that you
selected with the arrow on the tool body.
Torque
Applicable
operation
High
Heavy load-
ing operation
Low
Light loading
operation
2
3
4
7 ENGLISH