Makita 197413-5 사용 설명서 - 페이지 8

{카테고리_이름} Makita 197413-5에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 197413-5 13 페이지. Cordless cutter
Makita 197413-5에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사용 설명서 (12 페이지)

페이지 인쇄

NOTE: If the driver bit is not inserted deep enough

into the sleeve, the sleeve will not return to its original

position and the driver bit will not be secured. In this

case, try re-inserting the bit according to the instruc-

tions above.

NOTE: After inserting the driver bit, make sure that it

is firmly secured. If it comes out, do not use it.

Installing hook

► 1 . Groove 2. Hook 3. Screw

The hook is convenient for temporarily hanging the tool.

This can be installed on either side of the tool. To install

the hook, insert it into a groove in the tool housing on

either side and then secure it with a screw. To remove,

loosen the screw and then take it out.

OPERATION

The proper fastening torque may differ depending upon

the kind or size of the screw/bolt, the material of the

workpiece to be fastened, etc. The relation between fas-

tening torque and fastening time is shown in the figures.

Proper fastening torque for standard bolt

1. Fastening time (second) 2. Fastening torque

Proper fastening torque for high tensile bolt

1. Fastening time (second) 2. Fastening torque

Hold the tool firmly and place the point of the driver bit

in the screw head. Apply forward pressure to the tool to

the extent that the bit will not slip off the screw and turn

the tool on to start operation.

8 ENGLISH

N•m

(kgf•cm)

100

(1020)

(816)

(612)

(408)

(204)

N•m