KitchenAid KHMS1850SSS0 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} KitchenAid KHMS1850SSS0에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KHMS1850SSS0 13 페이지. Microwave hood combination
KitchenAid KHMS1850SSS0에 대해서도 마찬가지입니다: 부품 목록 (7 페이지)
페이지 인쇄
5. Rotate blower motor end over end.
6,
Rotate blower motor so that exhaust ports face the back of
microwave oven, and lower blower motor back into the
microwave oven,
Roof Venting Installation
Only
1. Repeat Step 1 from "Wall Venting Installation Only."
2. Repeat Step 2 from "Wall Venting Installation Only."
3. Repeat Step 3 from "Wall Venting Installation Only."
4. Repeat Step 4 from "Wall Venting Installation Only."
5. Rotate blower motor so that exhaust ports face the top of
microwave oven, and flat sides of blower motor face back of
microwave oven. Lower blower motor back into microwave
oven,
A
A. Exhaust port
7. Reattach blower motor to back of microwave oven with
2 screws removed in Step 3.
8. Reattach damper plate. Make sure tabs at top and back of
damper plate are inserted fully into their respective slots in the
microwave oven.
I
I
D E
A. Damper plate
B. Tabs at back of damper plate
C. Slots in back of microwave oven exterior
D. Damper plate tabs
E. Slots in top of microwave
oven exterior
9. Secure damper plate with screw.
A. Exhaust port
IMPORTANT: If blower motor is not positioned with flat sides
facing the back of the microwave oven (as shown), performance
will be poor.
6. Reattach blower motor to back of microwave oven with
2 screws removed in Step 3 of "Wall Venting Installation Only."
Securely tighten screws.
NOTE: If blower motor is not correctly oriented, the 2 screws
removed in Step 3 cannot be reattached to the microwave oven.
7. Reattach damper plate. Make sure tabs at top and back of
damper plate are inserted fully into their respective slots in the
microwave oven.
A
B C
D E
A. Damper plate
B. Tabs at back of damper plate
C. Slots in back of microwave
oven exterior
D. Damper plate tabs
E. Slots in top of microwave
oven exterior
8. Secure damper plate with screw.