KitchenAid KHMS1850SSS1 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} KitchenAid KHMS1850SSS1에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KHMS1850SSS1 12 페이지. Microwave hood combination
KitchenAid KHMS1850SSS1에 대해서도 마찬가지입니다: 사용자 지침 (6 페이지)

페이지 인쇄

Remove Mounting Plate

NOTE: To avoid possible damage to the work surface, cover the

work surface.

1. Remove any remaining contents from the microwave oven

cavity.

2. Remove the mounting plate and set aside.

A. Mounting plate

B. Back of microwave oven

3. Tape the microwave oven door closed so that door does not

swing open while the microwave oven is being handled.

NOTE: To avoid damage to the microwave oven, do not grip or

use the door or door handle while the microwave oven is being

handled.

INSTALLATION INSTRUCTIONS

Rotate Blower Motor

The microwave oven is set for recirculation installation. For wall or

roof venting, changes must be made to the venting system.

NOTE: Skip this section if you are using recirculation installation.

Keep the damper assembly in case the venting method is

changed, or the microwave oven is reinstalled in another location

where wall or roof venting may be used.

Wall Venting Installation Only

1. Remove screw attaching damper plate to top of microwave

oven exterior. Slide damper plate back and lift up.

A Screw

B. Damper plate

2. Keep damper plate and screw together and set aside.

3. Remove two screws attaching blower motor to back of

microwave oven.

4. Lift blower motor out of microwave oven.

A. Blower motor

A. Screws