Makita 6040DW 사용 설명서 - 페이지 6
{카테고리_이름} Makita 6040DW에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6040DW 13 페이지. Makita cordless drill user manual
페이지 인쇄
Charging
Connect the charging plug to the charg-
ing connector, then plug in the charger to
the power receptacle. Charging takes 3
hours.
CAUTION:
The battery in your new tool is not fully
charged. You will need to charge it be-
fore use.
Do not operate the tool during charging.
Overcharging more than 2 days consid-
erably shortens the battery service life.
Always unplug the charger after completing the charge.
When you charge a new tool or a tool which has not been used for
a
long period, it
may not accept a full charge. This
is a
normal condition and does not indicate
a
problem. You can recharge the tool fully after discharging
it
almost completely
a
couple of times.
Installing
or
removing driver bit
CAUTION
:
When installing or removing the bit, be careful not to touch the trigger switch.
To install the bit, place it in the chuck as
far as
it
will go. Tighten the chuck
by
hand. Place the chuck key in each of the
three holes and tighten clockwise.
Be sure to tighten all three chuck holes
evenly.
To remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
6