Makita 6093DW 사용 설명서 - 페이지 7
{카테고리_이름} Makita 6093DW에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6093DW 17 페이지. Equipped with electric brake 10 mm (3/8") with fast charger
Makita 6093DW에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)
페이지 인쇄
0
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Installing or removing drill bit or driver bit
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing
or
removing the bit.
To install the bit, place it in the chuck as
far as it will go. Tighten the chuck by hand.
Place the chuck key
in
each of the three
holes and tighten clockwise. Be sure
to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
I
Chuck key
Holding tool
Hold the tool as shown in the figure.
When drilling a large diameter hole, hold
the tool firmly with both hands.
7