Makita 6176D 사용 설명서 - 페이지 8

{카테고리_이름} Makita 6176D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6176D 17 페이지. Makita cordless driver drill instructions manual 6176d
Makita 6176D에 대해서도 마찬가지입니다: 부품 목록 (1 페이지), 사용 설명서 (17 페이지)

페이지 인쇄
Makita 6176D 사용 설명서
1
1. Reversing switch lever
F
1. Reversing switch lever
ASSEMBLY
1
3
1. Tighten
2. Sleeve
3. Ring
8

Reversing switch action

002074
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the "FWD" posi-
tion for clockwise rotation or the "REV" position for counter-
clockwise rotation.
When the reversing switch lever is in the neutral position, the
switch trigger cannot be pulled.
CAUTION:
004021
•
Always check the direction of rotation before operation.
•
Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation before
the tool stops may damage the tool.
1
•
When not operating the tool, always set the reversing
switch lever to the neutral position.
Overload protector (for 6176D only)
The overload protector automatically cuts out to break the
circuit whenever heavy work is prolonged. Wait 20 - 30 sec-
onds before resuming operation.
CAUTION:
•
Always be sure that the tool is switched off before
carrying out any work on the tool.
Installing or removing driver bit or drill bit
002112
CAUTION:
2
•
Always set the reversing switch lever to the neutral
position before installing or removing the bit.
Hold the ring and turn the sleeve counterclockwise to open
the chuck jaws. Place the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve clockwise to tighten
the chuck.
To remove the bit, hold the ring and turn the sleeve counter-
clockwise.