Makita 6216DWAE 사용 설명서 - 페이지 7

{카테고리_이름} Makita 6216DWAE에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6216DWAE 20 페이지.

Installing or removing battery cartridge

*Always switch off the tool before insertion

or removal of the battery cartridge.

*To remove the battery cartridge, withdraw

it from the tool while pressing the buttons

on both sides of the cartridge.

*To insert the battery cartridge, align the

tongue on the battery cartridge with the

groove in the housing and slip it into place.

Always insert it all the way until it locks in

place with a little click. If not, it may acci-

dentally fall out of the tool, causing injury

to you or someone around you.

*Do not use force when inserting the battery cartridge. If the cartridge does not slide in

easily, it is not being inserted correctly.

Charging

*Your new battery cartridge is not charged.

You will need to charge it before use. Use

the high capacity batten/ charger Model

DC1411 to charge the battery cartridge.

*Plug the high capacity battery charger into

the proper A.C. voltage source. The charg-

ing light will flash in green color.

*Insert the battery cartridge so that the plus

and minus terminals on the battery car-

tridge are on the same sides as their

respective markings on the hiah capacity

battery charger. Insert the cartridge fully into the port so that it rests on the charger port

floor.

*When the battery cartridge is inserted, the charging light color will change from green to

red and charging will begin. The charging light will remain lit steadily during charging.

*When the charging light color changes from red to green, the charging cycle is complete.

The charging time is approximately one hour.

*If you leave the battery cartridge in the charger after the charging cycle is complete, the

charger will switch into its "trickle charge (maintenance charge)" mode which will last

approximately 24 hours.

*After charging, unplug the charger from the power source.