Makita 6217D 기술 정보 - 페이지 8

{카테고리_이름} Makita 6217D에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6217D 13 페이지. Cordless driver drills 10mm, 13mm
Makita 6217D에 대해서도 마찬가지입니다: 사용 설명서 (10 페이지)

페이지 인쇄

epair

< 1 > Disassembling of drill chuck See Fig. 1.

For replacing gear assembly, drill chuck has to be disassembled.

Take the following steps.

1. Firmly hold No.1R139 "Drill chuck extractor" with vise. And lock spindle with the drill chuck extractor.

2. Open the jaws of drill chuck fully and take off flat head screw M6 x 22 by turning clockwise.

3. Disassemble drill chuck with hex wrench inserted into drill chuck by turning the hex wrench anti-clockwise.

If drill chuck is damaged, firmly hold the drill chuck with vise and turn spindle with wrench anti-clockwise

as illustrated in fig. 1A.

1R139 Drill chuck extractor

< Note >

For replacing other than gear assembly, it is not necessary to disassemble drill chuck.

< 2 > Disassembling housing See Fig. 2.

1. Take off brush holder caps and carbon brushes.

2. Slide mode change lever to the drill mode side.

3. Unscrew the following screws.

* Tapping screw PT 3 x 16 : 9 pcs.

* Pan head screw M 4 x 22 : 1 pc.

Mode change lever

Slide mode change lever

to the drill mode side.

Brush holder cap

Fig. 1

Carbon brush

Fig. 2

Fig. 1A

Tapping screw bind

PT 3x16 : 9 pcs.

P 8 / 13

Brush holder cap

Carbon brush

Pan head

screw M4 x 22 : 1 pc.