Broadcom 9460-8i 시작하기 매뉴얼 - 페이지 2

{카테고리_이름} Broadcom 9460-8i에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Broadcom 9460-8i 2 페이지. Pcie storage adapter

페이지 인쇄

Handling Instructions

The handling and usage instructions stated herein are general guidelines for board-level products.

Individual board-level products may have additional instructions and requirements in the applicable

product specification, which should be consulted.

• Complete all handling at an electrostatic discharge (ESD)-safe workstation with ESD-safe tools. The

workstation and tools must comply with IPC-A-610 at a minimum or ANSI/ESD S20.20.

• Handle by the edges of the base board. Do not handle the board by the bracket, heat sinks, or any

installed daughter board or DIMM memory.

• Do not stack boards after removing them from their shipping containers. Place boards on a flat, ESD-

safe surface with the top side of the board up to prevent damage to the heat sink.

• Do not bend or twist the board at any time. Any stress that exceeds 500 micro-strain, or 500 micro-

inches of deflection per inch of board material in any direction, could damage the board. Broadcom

follows the IPC/JEDEC-9704 industry standard.

• When installing the board in a system, press down evenly on the top corners of the base board to

avoid contact with brackets, heat sinks, or any installed daughter board or DIMM memory.

• When installing cables, align the cable with the board-mounted connector. Do not force the cable

into the connector, and orient any polarized cables properly.

• Refer to the board Quick Installation Guide for complete instructions on changing the bracket,

including screw torque specifications.

• Disconnect the power before removing or replacing the board.

• Do not allow any fluid or any material that is conductive or corrosive to contact the board.

• The boards are designed to operate in an ambient environment of 10 °C to 55 °C (dry bulb). The

relative humidity environment should be between 20% and 80% (non-condensing).

• To avoid overheating, make sure the minimum required airflow is applied. Refer to the board Quick

Installation Guide for more information.

For product information and a complete list of distributors, please go to our website: www.broadcom.com.

Broadcom, the pulse logo, Connecting everything, Avago Technologies, and the A logo are the trademarks of Broadcom in

the United States, certain other countries and/or the EU.

The term "Broadcom" refers to Broadcom Limited and/or its subsidiaries. For more information, please visit

www.broadcom.com. Broadcom reserves the right to make changes without further notice to any products or data herein

to improve reliability, function, or design.

Information furnished by Broadcom is believed to be accurate and reliable. However, Broadcom does not assume any

liability arising out of the application or use of this information, nor the application or use of any product or circuit described

herein, neither does it convey any license under its patent rights nor the rights of others.

5972-4867-P0

January 20, 2017.

TECHNICAL SUPPORT

For assistance installing, configuring, or running

the adapter, contact Broadcom Technical

Support:

Website:

www.broadcom.com

WARRANTY NOTICE

The warranty does not cover the return of

parts damaged by changing the bracket.

The warranty does not cover ESD damage to

the adapter. Adapters returned without a bracket

mounted on the board will be returned without

return merchandise authorization (RMA)

processing.