Makita 6303 사용 설명서 - 페이지 6
{카테고리_이름} Makita 6303에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6303 8 페이지. 13mm (1/2") drill
Makita 6303에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 사용 설명서 (8 페이지)
페이지 인쇄
Drilling operation
Drilling in wood
When drilling in wood, best results are obtained with wood drills equipped with a guide
screw. The guide screw makes drilling easier by pulling the bit into the workpiece.
To prevent the bit from slipping when starting
a
hole, make an indentation with a center-
punch and hammer
a t
the point to be drilled. Place the point of the bit in the indenta-
tion and start drilling.
Use a cutting lubricant when drilling metals. The exceptions are iron and brass which
should be drilled dry.
Drilling in metal
CAUTION :
*Pressing excessively on the tool will not speed up the drilling. In fact, this excessive
pressure will only serve to damage the tip
of
your bit, decrease the tool performance
and shorten the service life of the tool.
*There is a tremendous force exerted on the tool/bit
a t
the time of hole break through.
Hold the tool firmly and exert care when the bit begins to break through the workpiece.
*Always grip the small workpiece firmly with a vise or
a
holding means.
* A stuck bit can be removed simply by setting the reversing switch to reverse rotation
in order to back out. However, the tool will pull away easily unless you hold it firmly
before starting the tool.
MAINTENANCE
CAUTION
:
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and
replacement, any other maintenance or adjustment should be performed
by
Makita
Authorized or Factory Service Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
The accessories listed in this manual are available at an extra cost from your Makita distributor or Makita factory
service center. Service centers are listed on the warranty card packed with your tool.
CAUTION
:
These accessories o r attachments are recommended f o r use w i t h y o u r Makita
tool
specified in this
manual. The use of any other accessories or attachments m i g h t present a risk of i n j u r y t o persons. The
accessories or attachments should be used o n l y in the proper and intended manner.
Chuck key
Part No. 763420-6
0
G r i p
32
Part No. 2 7 3 4 0 6 - 7
6