Gardena ErgoJet 2500 사용 설명서 - 페이지 9

{카테고리_이름} Gardena ErgoJet 2500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena ErgoJet 2500 18 페이지. Electric blower/vac
Gardena ErgoJet 2500에 대해서도 마찬가지입니다: 사용 설명서 (19 페이지), 사용 설명서 (19 페이지), 사용 설명서 (17 페이지), 사용 설명서 (10 페이지), 사용 설명서 (9 페이지), 운영자 매뉴얼 (8 페이지)

페이지 인쇄

Starting the blower:

Working positions:

WARNING:

extension cord. Wait until the impeller has completely stopped turning,

then remove the vacuum tubes. Carefully reach into the vacuum opening

and clear out the clogged debris.

This will reduce possible personal injury from the impeller.

Switching the blower on:

Move the ON/OFF switch

unit.

NOTE: For ErgoJet 3000 (EJ 3000) only: The motor speed can

be increased or decreased by using the variable speed control

CAUTION: To avoid causing damage to the unit, only use the

variable speed control in blow mode. DO NOT attempt to use the

variable speed control in vacuum mode. Lower speeds during

vacuum use could allow debris to build up, stall the motor and

cause unit failure.

Switching the blower off:

To stop the unit, move the ON/OFF switch

OFF (0) position.

Blow mode

Use your unit as a blower for sweeping debris or grass clippings

from driveways, sidewalks, patios, etc. Also, for blowing grass

clippings, straw, or leaves into piles, or removing debris from

corners, around joints, or between bricks.

For ErgoJet 3000 (EJ 3000) only:

Use the variable speed control to increase or decrease the motor

speed during blower use.

Direct air flow by directing the blower tube down or to one side.

Always work away from solid objects such as walks, large stones,

vehicles, and fences.

Clean corners by starting in corners and moving outward. This will

help prevent an accumulation of debris which could fly into your

face. Be careful when working near plants. The force of the air

could damage tender plants.

Vacuum mode

Use your unit as a vacuum to pick up dry material such as leaves,

grass, small twigs, and bits of paper.

For best results during vacuum use, operate your unit at high

speed.

Move slowly back and forth over the material as you vacuum.

Avoid forcing the unit into a pile of debris as this can clog the unit.

Keep the vacuum tube about an inch above the ground for best

results.

If the unit becomes clogged, stop the unit and unplug the

to the ON (I) position to turn on the

to the