Gardena ErgoJet 3000 사용 설명서 - 페이지 8

{카테고리_이름} Gardena ErgoJet 3000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena ErgoJet 3000 18 페이지. Electric blower/vac
Gardena ErgoJet 3000에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지), 사용 설명서 (19 페이지), 사용 설명서 (19 페이지), 사용 설명서 (17 페이지), 사용 설명서 (10 페이지), 운영자 매뉴얼 (8 페이지)

페이지 인쇄

Converting unit from vacuum

use to blower use:

4. Operation

WARNING:

attached to avoid flying debris and/or impeller contact which can cause serious

injury. Always wear gloves and use eye protection to prevent rocks or debris from

being blown or ricocheting into the eyes and face which can result in blindness or

serious injury.

Cables:

Connecting the unit –

cable lock/extension cables:

1. Stop unit and unplug the extension cord.

2. Remove the elbow tube and collection bag.

3. Remove the vacuum tubes by releasing the latch on the vacuum

inlet cover and rotating the cover until the tubes are released

from the latches of the retaining posts.

4. Close the inlet cover and make sure it is latched closed.

5. Re-install the blower tube. Refer to FITTING THE BLOWER

TUBE for instructions on how to attach this item.

NOTE: A safety switch will prevent the unit from starting if the inlet

cover is not latched closed.

Do not use the unit without the tubes or collection bag properly

Use only 1.00mm

Maximum rating:

1.00mm

size cable

ErgoJet 3000 (EJ3000): 3000 W

ErgoJet 2500 (EJ2500): 2500 W

Mains cables and extensions are available from your local

approved service centre. Only use extension cables specifically

designed for outdoor use.

Loop the extension cable

This prevents unintentional separation of the electrical connection.

Then connect it to the mains cable.

size cable up to 40 metres length maximum.

and insert it into the cable lock