Makita 6312DWG 사용 설명서 - 페이지 8
{카테고리_이름} Makita 6312DWG에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6312DWG 16 페이지. Cordless driver drill equipped with electric brake
페이지 인쇄
0
I f you charge a battery cartridge from a just-operated tool or a battery cartridge which
has been left in a location exposed t o direct sunlight or heat for a long time, the charg-
ing light may flash in red color. I f this occurs, wait for
a
while. Charging will begin after
the battery cartridge cools. The battery cartridge will cool faster i f you remove the
battery cartridge from the fast charger.
0
If the charging light flashes alternately in green and red color and a tone sounds "beep,
beep, beep,
. . ."
for about 20 seconds, a problem exists and charging i s not possible.
The terminals on the charger or battery cartridge are clogged with dust or the battery
cartridge is worn out or damaged.
0
If you wish t o charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Installing or removing driver bit or drill b i t
CAUTION :
Always be sure that the tool i s switched off and the battery cartridge i s removed before
installing or removing the bit.
To install the bit, push the sleeve up to-
ward the "FREE" side and turn the sleeve
counterclockwise while holding the ring
with your other hand
as
illustrated at right.
Place the bit in the chuck as far as
it
will
go. Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck. Then push
the sleeve down toward the "LOCK" side.
See illustration.
A
FREE
side
Sleeve
I
LOCK
side
To remove the bit, push the sleeve up toward the "FREE" side and turn the sleeve
counterclockwise while holding the ring with your other hand.
CAUTION :
.Do
not attempt t o turn the sleeve forcibly when the sleeve is in the"L0CK" position.
The sleeve may be damaged.
.Always push the sleeve down toward the "LOCK" side before operation. I f you operate
the tool with the sleeve in the
"FREE"
position, the chuck may loosen and the bit may
come out unexpectedly.
8