A&I Products A-C7481O 설치 매뉴얼 - 페이지 6

{카테고리_이름} A&I Products A-C7481O에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A&I Products A-C7481O 7 페이지.

If the width of the ROPS is greater or less than 35" wide, the top and bottom brackets will be needed. These

brackets will allow adjustment to fit ROPS that are 27" to 40" in width. Use (6) 3/8" bolts and (6) 3/8" nuts

per bracket, two bolts and nuts are required for each slot. The orientation of the side mount plates will

depend on the angle of the ROPS.

Fig. 4

The side mount plates are reversible to accommodate forward and rear angled ROPS. The side mount plates

are slotted, this will allow adjustment to level the canopy once installed. The orientation of the side mount

plates is shown below (the curved edge will match the angle of the ROPS).

Fig. 2