A&L Furniture AL284PT-UNF 조립 지침

{카테고리_이름} A&L Furniture AL284PT-UNF에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. A&L Furniture AL284PT-UNF 2 페이지. 44” square walk-in table

Assembly Instructions for 44" Square Walk-In Table

Tools Needed:

Power drill or screwdriver

#2 Square Drive Bit

Hardware:

4 – 2¾" Wafer Head Bolts

75– 2" Screws

1 - Allen Wrench

Lay the table tops upside down & bolt together. Insert the four 2¾" bolts in the predrilled holes in one side

& turn into the threaded inserts with the Allen Wrench. (See photo 1.) Now, attach the 2"x2"x35" strips, use

six 2" screws in each strip. Turn into the predrilled holes and screw down into the table top. (See photo 2.)

Assemble the 4 bench legs. Take two leg supports and attach to a bench bottom. Put two 2" screws in the

predrilled holes in each end of the bench bottom and screw into one end of the leg supports. (See photo 3.)

Predrilled

holes in leg

supports

belong at

this end

Unfold a table leg assembly & place upside down on a table. (See photo 4.) Take a bench top & place up-

side down with the center 2x2 between the 2x4 table leg support beams. Attach with two 2" screws on

each side (See photos 4 and 5)

photo 1

photo 3

Parts List:

Table Top—2 pieces

2"x2"x35" Strips—2 pieces

Table Leg Assemblies—2 pieces

Bench Tops - 4 pieces

1"x5½"x14½" Bench Leg Supports—8 pieces

1"x5½"32" Bench Bottoms—4pieces

Step 1

Step 2

photo 4

Step 3

photo 2

*Keep 2x2 even with leg supports*

photo 5