AlienPro MU-100 운영 매뉴얼 - 페이지 3
{카테고리_이름} AlienPro MU-100에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AlienPro MU-100 5 페이지.
페이지 인쇄First Things First
Before installing your wireless microphone, there are a few things you should
do and know:
Make sure your local power outlet supplies the correct voltage for the DC
adapter.Only use the adapters supplied with the system.
Turn offyour audio system during set-up and turn down volume.
Fully charge your batteries before using the system.
Plug the power adapter cord jack into the matching power socket on the
rear of the receiver. Make sure the power switch is OFF "0" and all volume
controls are turned down to the negative position before beginning any
installation
Do not dismantle the receiver on your own.For needed repairs, contact
your dealer
Care and Cleaning
Make sure the power is disconnected before cleaning the receiver unit. Use a
soft cloth to clean the receiver and microphones. DO NOT use chemicals or
any cleaning agents to clean the receiver or microphones.
If you will not be using the system for an extended period of time,
disconnect all power sources. Remove the batteries from microphones.
w w w . a l i e n p r o . c o m . m x
2
Parameter/Receiver
Carrier Wave Frequency Range
Oscillation Mode
Carrier Wave Stability
Sensitivity
S/N Ratio
T.H.D.
Image Rejection
Spurious Rejection
Frequency Responses
Working Distance
Squelch Control
AF Output Impedance
Max. Output Level
Display
Power Supply
Output Connector
Dimensions (m/m)
Transmitter
Transmitter Power
Spurious Emission
Display
Battery Voltage
Battery Life
Frequency Response
UHF 614~698MHz 740~900MHz
Quartz Controlled Fixed Frequency
10PPM
-105dB @ sinad=12 dB
>105dB
<0.5% @ 1KHz
85 dB typical
75 dB typical
40Hz~18KHz
200 feet
dual-squelch circuit
2.2KÙ
Balance : 0-400mv, Unbalance : 0-200mv
LED
External DC Power Supply, 0.35A, 12~18V DC
XLR Balanced Socket
Unbalance TRs 6.35mm Socket
206(L)
41(H)
130(D)
30mW
<40dB(with carrier)
LED
1.5v 2
10 hours
w w w . a l i e n p r o . c o m . m x
7