A&R Power Amplifier SA200 소유자 핸드북 매뉴얼 - 페이지 12

{카테고리_이름} A&R Power Amplifier SA200에 대한 소유자 핸드북 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A&R Power Amplifier SA200 14 페이지. Stereo power amplifiers
A&R Power Amplifier SA200에 대해서도 마찬가지입니다: 소유자 핸드북 매뉴얼 (14 페이지)

페이지 인쇄

SA150 Technical Specification

Inputs

Fixed level inputs are connected to pin 3 (LEFT) and pin 5 (RIGHT) of a 5 pin 180° DIN socket

and/or two phono sockets located in the rear sub panel. This sub panel is removable to allow

other types of connector to be substituted, if required.

Sensitivity

0.87V (ref. 75W/8ohms. 1 kHz)

Gain to loudspeaker terminals

29.0 dB at 1 kHz, non-in verting

Signal/noise ratio

> 100 dB, unweighted or CCIR/ARM

weighted, (ref. 75W/8 ohms)

Input impedance

20 kfl

Outputs

Loudspeaker outputs are via red and black heavy duty screw terminals. These will accept bare

wires or 4mm ('Banana') plugs. Suitable for 4-16 ohm loudspeakers.

The continuous power output, both channels driven (at 0.08% t.h.d., 20 Hz-20 kHz), exceeds

75W/channel into 8 ohms

110W/channel into 4 ohms

The typical maximum power output at 1 kHz, at clipping (0.1% t.h.d.), both channels driven is

90W/channe! into 8 ohms

125W/channel into 4 ohms

Total Harmonic Distortion

At any level up to 75W/8 ohms, 1 kHz > 0.03% (typ. 0.01%)

At any level up to 110W/4 ohms, 1 kHz > 0.05% (typ. 0.02%)

Frequency Response

+ 0, - 0.5 dB 10 Hz-20 kHz. It is recommended that the pre-amplifier's high frequency response

should be curtailed to at least - 3 dB at 50 kHz.

Power Requirements

240VAC, 48-63 Hz, 500VA maximum. The unit may be dealer adjusted to work at 220V or

120V if required.

Dimensions (overall)

Width

464mm (18V4H)

Height

95mm (33A")

Depth

350mm (133/4")

Weight

Net 9 kg (20 lb)

Packed 13 kg (29 lb)