Align Trex SE 설정 매뉴얼 - 페이지 3

{카테고리_이름} Align Trex SE에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Align Trex SE 14 페이지. Helicopter

Align Trex Se Setup Guide

The radio settings should now be very close to final with the exception of possible servo reversing, subtrims and gyro

gain adjustments.

#2 Servo mounting, connections, direction and centering

Servo mounting may vary slightly but I found the following offers good alignment. Servo connections shown are for

the DX6.

Note Ch. 6 servo is mounted from the inside and Ch. 3 is mounted from the outside of the left frame with the servo

horn inside the frame halves.

http://www.digimemphoto.com/pdf/ (3 of 13)1/25/2006 7:09:05 PM

CP2 and CP3 can be increased if you are experienced or after you become

comfortable with your heli. The transmitters default setting of 60% will give

you about 12 degrees total cyclic travel, [ -, + 6 degrees]. At this high setting

the mechanics are very near binding. In addition using that much cyclic may

cause bogging. Shoot for 6 degrees total and then advance to around 9

degrees total.

Figure A

Figure B