Align Trex SE 설정 매뉴얼 - 페이지 7
{카테고리_이름} Align Trex SE에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Align Trex SE 14 페이지. Helicopter
페이지 인쇄Align Trex Se Setup Guide
Push the collective (left stick) all the way up.
Level the blades and flybar by lifting on the guage.
The top of the guage and flybar should be parallel or very close. (figure I below)
If more pitch is needed to get +10 degrees we will need to access the Function Mode on the
transmitter.
Now we check the negative pitch.
Set your pitch guage to -10
Place it on one of the main blades.
Pull the collective (left stick) all the way down.
Level the blades and flybar by lifting on the guage.
The top of the guage and flybar should be parallel or very close. (figure K below).
http://www.digimemphoto.com/pdf/ (7 of 13)1/25/2006 7:09:05 PM
With the transmitter already on, press scroll and increase at the same time.
Press scroll until MIX CP2 is displayed.
Press channel until MIX CP6 is displayed.
Use increase to add more collective. You should see the collective increase as you make
the adjustment. Increase until +10 is obtained.
Check clearance A between the top of the washout base and bottom of the main
rotor housing (figure J below). The gap can be tighter than what is shown but they
surfaces should not be butted together.
If you are unable to reach +10 degrees before the surfaces touch, there is a
problem with linkage elsewhere. Go back and recheck your linkage.
Check clearance B between the top of the collar and bottom of the swashplate (figure L
below).
If you are unable to reach -10 degrees before the surfaces touch, there is a problem
with linkage elsewhere. Go back and recheck your linkage.
Figure I
Figure J