Align APS030-2200 운영 매뉴얼 - 페이지 5

{카테고리_이름} Align APS030-2200에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Align APS030-2200 14 페이지. 100,000 lbs. capacity battery powered tugger

PTT6 Power Tugger

II. Safety

PTT6 Safety

Charge the batteries after using the PTT6 Tugger.

Always place the female coupling (1a) at the correct

height. It's important that the coupling is at the correct

angle and is firmly fastened to your trailer.

Raise / lift the coupling until the casters have enough

ground clearance (1.5").

Only lift the coupling high enough to perform the transport.

Load Placement

The image below shows the correct setup that should be used with the PTT6, as well as where to

place the load. These trailers should consist of one wheel axle. When the trailer and the PTT6's cou-

pling are attached to each other, and the PTT6's arm is raised, the trailer leg will be lifted off

the ground.

As mentioned above, trailers should consist of one wheel axle. If there are two axles and the floor is

uneven, the front wheel will be lifted up by the PTT6 and overload the wheels. Uneven floors put the

trailer coupling at risk of unfastening and can disconnect from the trailer.