Align-Pilates C1 조립 지침 매뉴얼 - 페이지 8
{카테고리_이름} Align-Pilates C1에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Align-Pilates C1 16 페이지. Full cadillac
Now that the brackets are in place you can insert the upright poles. Please ensure the grub screws on the
brackets have all been released to allow the poles to slide in easly. At the head end the two poles with the
holes along their length are inserted with the holes at the top and facing outward away from the reformer.
At the foot end the poles can be inserted with the holes at the top as shown in Figs.7 & 8.
Fig.7
Fig.8
Now you can attach the carriage brackets on to the head end poles with one pair of normal brackets
going on first, slide these to the bottom, Fig.9. Then slide the two push through bar carriages onto the
poles and lock into place (Fig.9) and then finally the third pair of carriage brackets as in the picture below
Fig.9.
Fig.9
Fig.10
At the foot end of the reformer you can now slide over the roll down bar frame. It is held in place by two
knobs which you screw in to each side of the frame in the holes provided.
The 'halo' or top frame of the Cadillac will arrive already built with the trapeze frame already attached.
Lower the Halo onto the top of each of the poles corners and then use the eyelets to secure into place
using the tools provided, see Fig.10. Once all four corners are attached the result should be as Figs 11.
Fig.10
Fig.11
8