ALIGNER CCD2.0WIFI 설치 및 설명서 - 페이지 5
{카테고리_이름} ALIGNER CCD2.0WIFI에 대한 설치 및 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ALIGNER CCD2.0WIFI 16 페이지.
페이지 인쇄
2 CONNECTIONS
2.1 Power line connection
The alignment sensor panels must be connected to the
power used is 100W.
Use the power outlet located on the side of the panels.
The panels can be connected to the network separately (on two different walls) or the right panel can be
powered on the power strip behind the left panel, as in the example in Figure 3.
ATTENTION: The power line should not be turned off during the night as the detectors must be recharged.
The batteries of the detectors are recharged when they are placed on the dedicated charging supports on
the panel. These supports carry 7.5V DC power supply.
Attention: The +/‐ poles must be correct, check them when the detector is being charged.
If the +/‐ poles are correct, the battery is charged (the green LED is on); if they are inverted it will NOT charge.
Figure 4
shows the schematic diagrams of the two detector panels.
Note: the power supply board of the charging supports code 18878 has 4 0/7.5V outputs, but only 2 are used.
115/230Vac 50/60Hz power line; the maximum
Figure 3
LEFT PANEL
RIGHT PANEL
Figure 4
R0368
Cod. R0368 ‐ rev.1.0
(03/2020)
Page 3/14