a'-tek a1303 사용 설명서

{카테고리_이름} a'-tek a1303에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. a'-tek a1303 1 페이지.

a1303 instruction manual

home zone:

a) setting the time

1. pull the crown out to the 1st click position.

2. turn the crown to set hour and minute hands.

3. after the time has been set, push the crown back to the normal position

local zone:

a) setting the time

1. pull the crown out to the 2nd position.

2. turn the crown to set hour and minute hands.

3. when the crown is pushed back to the normal position, small second hand begins to run.

b) setting the date

1. pull the crown out to the 1st position.

2. turn the crown counter-clockwise to set the date.

*if the date is set between the hours of around 9:00 pm and 1:00 am, the date may not change on the

following day.

3. after the date has been set, push the crown back to the normal position.

c) using the chronograph

this chronograph is able to measure and display time in 1/1 second united up to maximum of 59 minutes 59

seconds.

the chronograph second hand keeps continuously for 59 minutes 59 seconds after starting.

measuring time with the chronograph

1. the chronograph can be started and stopped each time pusher "a" is pressed.

2. pressing pusher "b" resets the chronograph and the chronograph second hand and chronograph minute

hand return to zero position.

d) chronograph reset (incl. after replacing battery)

this procedure should be performed when the chronograph second hand does not return to zero position

after the chronograph has been reset, and including after the battery has been replaced.

1. pull the crown out to the 2nd position.

2. press pusher "a" to set the chronograph second hand to the zero position. the chronograph hand can

be advanced rapidly by continuously pressing pusher "a".

3. once the hand have been zeroed, return the crown to the normal position.

* do not push crown to normal position while the chronograph second hand returns to zero position. it

stops on the way when crown are returned to normal position and its position is recognized as zero

position.