Garmin 400W Series 매뉴얼 - 페이지 12

{카테고리_이름} Garmin 400W Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin 400W Series 22 페이지. Bell 206b
Garmin 400W Series에 대해서도 마찬가지입니다: 추가 비행 매뉴얼 (16 페이지), 파일럿 매뉴얼 부록 (24 페이지), 매뉴얼 보충 자료 (14 페이지), 파일럿 매뉴얼 부록 (50 페이지), 빠른 참조 매뉴얼 (25 페이지), 사용 설명서 (26 페이지)

페이지 인쇄
Garmin 400W Series 매뉴얼
2.6.1 400W Series Alerts
The 400W Series will display a number of alerts. These are listed in the following table.
Alert Text
Airport terrain database
integrity error
Aviation database integrity
error
Basemap database integrity
error
Boot block verify failed -
Return unit for repair
CDI key stuck
CDI key disabled
Check unit cooling
COM has failed 420W and
430W only)
400W Series
Instructions for Continued Airworthiness Bell 206B
Table 3. 400W Series Alert Troubleshooting Guide
Possible Cause
• The 400W Series unit has
detected a problem with a
database on the Terrain data
card. The message
"<database name> database
integrity error" indicates the
data base in error.
• The 400W Series unit has
detected a problem with a
database on the NavData®
card. The message
"<database name> database
integrity error" indicates the
data base in error.
• The 400W Series unit has
detected a failure in the built-in
basemap (land data) database.
Land data does not appear on
the Map Page. Other unit
functions continue to work
normally.
• System integrity testing has
determined that the boot block
has become corrupted.
• The CDI key is stuck in the
enabled (or "pressed") state.
Try pressing the CDI key again
to cycle its operation.
• "Ignore CDI key" has been
selected on the MAIN
CDI/OBS CONFIG page.
• The 400W Series unit has
detected excessive display
backlighting temperature. The
backlighting has been
automatically dimmed to
reduce the temperature.
• The unit has detected a failure
in its communications
transceiver.
Solution
• The data is not usable, try
reloading the information onto
the card. If that does not solve
the problem replace the card.
• The data is not usable, try
reloading the information onto
the card. If that does not solve
the problem replace the card.
• Reload the Basemap database
• Contact Garmin technical
support.
• Contact Garmin technical
support.
• Go to the MAIN CDI/OBS
CONFIG page and deselect
"Ignore CDI key"
• Check for adequate ventilation
or check cooling airflow.
• Contact Garmin technical
support.
190-01226-04 Rev. 2
Page 12 of 22