Garmin 500W Series 사용 설명서 - 페이지 9

{카테고리_이름} Garmin 500W Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin 500W Series 11 페이지. Continued airworthiness
Garmin 500W Series에 대해서도 마찬가지입니다: 파일럿 매뉴얼 부록 (24 페이지), 추가 비행 매뉴얼 (17 페이지), 파일럿 매뉴얼 부록 (50 페이지), 빠른 참조 (25 페이지), 사용 설명서 (26 페이지), 사용 설명서 (23 페이지)

2.7.3 Flight Stream 210 Bonding Strap

The following removal and replacement steps are provided as guidance for replacing the

Flight Stream 210 bonding strap. The bonding strap assembly drawing is shown in Figure 2.

Note: Aircraft structure side of bonding strap may be mounted using a nut in lieu of a nut plate. If a nut

was used in lieu of a nut plate, further disassembly of the aircraft may be required to gain access to the

nut.

Removal

1. Disconnect one end of the bonding strap from the aircraft ground location.

2. Disconnect the other end of the bonding strap from the shield block on the Flight Stream 210

connector backshell.

3. Remove the bonding strap.

Replacement

Note: The Flight Stream 210 bonding strap should be as short as practical. When installed, the bonding

strap must not loop back on itself.

1. Construct a bonding strap no longer than 20" by attaching clean terminal lugs to both ends of

clean braid (see Table 1 for parts required).

2. Clean the attachment locations with a bonding brush.

3. Secure each end of the bonding strap to the previously installed locations. Ensure that the strap

does not loop back on itself and that the hardware is as shown in Figure 2. The washers must

seat fully against the aircraft metallic structure without overhang or interference with other

hardware.

4. Using a milliohm meter, verify that the resistance between the connected structure is less than

10 milliohms.

In the event of a bonding test failure, remove the bonding strap from the aircraft ground point

and clean the attachment points with a bonding brush. Re-install the bonding strap and perform

the electrical bonding test in accordance with Section 2.5.4.

5. Replace any damaged hardware, otherwise hardware may be reused.

500W Series

Instructions for Continued Airworthiness

190-00357-65 Rev. D

Page 9 of 12