Alinco DR-510E 사용 설명서 - 페이지 11

{카테고리_이름} Alinco DR-510E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alinco DR-510E 16 페이지. Vhf/uhf dual band fm transceiver
Alinco DR-510E에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 사양 (2 페이지)

페이지 인쇄
Alinco DR-510E 사용 설명서
VHP or UHF Band Scan
This Scan will cover the entlre tun-
ing ränge of VHP or UHF.
1. Press the VFO/M key to select
the VFO mode, then select the
band, VHF or UHF.
2. Store the same frequency Into
Memory Channels A and 8.
3. Betöre pressing the SCAN key,
adjust the SQL control to the
threshold level.
4. Press the SCAN key to Initiate
Scan.
5. To clear scanning, press the
SCAN key or the microphone
P.T.T. Switch.
•The transceiver will stop on a busy
Channel until the Signal drops.
After a Short delay the scan will
resume.
•If you want to resume scanning
when the transceiver stops on a
busy Channel, rotate the Main Dial
or press the microphone UP/
DOWN buttons.
PRIORITYSCAN
The following Priority Scan options are
available:
Memory Priority Scan
VFO Priority Scan
CALL Priority Scan
A. Memory Priority Scan
1. Store the desired priority fre
quency into any Memory.
2. Select VFO mode, and dial up
the frequency you want to oper-
ate on.
3. Press the PRI key to initiate
Memory Priority Scan.
The transceiver will scan the
Priority in Memory for 1 second
out of 6 seconds and the VFO
frequency for the remaining 5
seconds.
4. When a Signal is present on the
Priority Memory Channel, press
the PRI key, and then press the
VFO/M key. The Priority scan
will stop and the Memory Chan
nel will come to the display.
B. VFO Priority Scan
This function is the reverse of Mem
ory Priority Scan.
1. Select VFO mode, and dial up
the frequency to be scanned.
2. Select the desired Memory you
want to operate on.
3. Press the PRI key to initiate VFO
Priority Scan.
4. To cancel this scan, press the
PRI key again.
-11-