AEG BCE556350M 사용자 설명서 - 페이지 32
{카테고리_이름} AEG BCE556350M에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG BCE556350M 40 페이지.
페이지 인쇄32
www.aeg.com
Clean the moisture from the cavity after
each use.
11.2 Cleaning the cavity
embossment
The cleaning procedure removes
limestone residue from the cavity
embossment after cooking with steam.
For the function: True Fan
Cooking PLUS we
recommend to do the
cleaning procedure at least
every 5 - 10 cooking cycles.
1. Put 250 ml of white vinegar into the
cavity embossment at the bottom of
the oven.
Use maximum 6% vinegar without
any additives.
2. Let the vinegar dissolve the residual
limestone at the ambient
temperature for 30 minutes.
3. Clean the cavity with warm water and
a soft cloth.
11.3 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
CAUTION!
Be careful when you remove
the shelf supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
2
Install the removed accessories in the
opposite sequence.
The retaining pins on the
telescopic runners must
point to the front.
11.4 Catalytic cleaning
The cavity with a catalytic coating is self-
cleaning. It absorbs fat.
Before you turn on the catalytic cleaning:
• remove all the accessories and
removable shelf supports.
• clean the oven floor with warm water
and mild detergent.
• clean the inner door glass with warm
water and soft cloth.
1. Set the function
You cannot change the duration of the
Catalytic cleaning. You can delay the
start of the cleaning with the function:
END.
The signal sounds at the end of cleaning.
2. Press any button to stop the signal.
3. Turn off the oven.
To stop the cleaning before it finishes
turn the knob for the heating functions to
the off position.
4. When the oven cools down, clean
the cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.5 Cleaning reminder
As a reminder that catalytic cleaning is
necessary, CATA flashes in the display
for 10 seconds after each activation and
deactivation of the oven.
The cleaning reminder goes out:
• after the end of the Catalysis function.
.