AEG BE3003001 사용자 설명서 - 페이지 27

{카테고리_이름} AEG BE3003001에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG BE3003001 32 페이지. Aeg oven
AEG BE3003001에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지), 사용자 설명서 (36 페이지), 사용자 설명서 (28 페이지), 사용자 설명서 (28 페이지), 사용자 설명서 (32 페이지)

페이지 인쇄

Install the shelf supports in the opposite

sequence.

The retaining pins on the

telescopic runners must

point to the front.

10.3 Oven ceiling

WARNING!

Deactivate the appliance

before you remove the

heating element. Make sure

that the appliance is cold.

There is a risk of burns.

Remove the shelf supports.

You can fold down the heating element

on the oven ceiling to clean the oven

ceiling easily.

1. Hold the heating element with two

hands at the front.

2. Pull it forwards against the spring

pressure and out along the supports

on the two sides.

The heating element folds down.

3. Clean the oven ceiling.

4. Install the heating element in the

opposite sequence.

Install the heating element

correctly above the supports

on the inner walls of the

appliance.

5. Install the shelf supports.

10.4 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

3. Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side

down on a soft cloth on a stable

surface. This is to prevent scratches.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them

up out of the guide.

ENGLISH